Skip to content
MSHA's Safety Targets Program
Lock Out/Tag Out (Metal/Nonmetal)

The Do's and The Don'ts

The Do's
  • Follow the Lock Out/Tag Out procedure established by your company.
  • Personally de-energize, lock out and tag out all power circuits and electrical equipment before any work is done on such circuits and equipment.
  • Personally de-energize, lock out and tag out all start-up switches on mechanical equipment before any work is done on such equipment.
  • Make sure that each person working on an electrical circuit or system applies his or her own personal lock and tag.
  • Make sure that all persons, including you, are in a safe location before energizing any equipment.
  • Wear appropriate Personal Protective Equipment, including electrically rated gloves, hard hat, and eye protection.
  • Always maintain de-energizing devices in operable condition.
  • Always block machinery against motion even after it has been locked out and tagged out.
  • Always familiarize yourself with electrical circuits before you perform any electrical work. Ask for help or consult a wiring diagram/schematic.
  • Make sure that electrical work is performed only by a qualified electrician or persons trained to do electrical work under the direct supervision of a qualified electrician.
  • Make sure that all electrical circuits and circuit breakers are properly identified before troubleshooting or performing electrical work.
  • Check for proper grounding of power conductors where required.
  • Use properly rated non-contact voltage testers to ensure that circuits are de-energized.
  • Provide an audible or visible warning system to warn persons that a conveyor is starting.
  • Maintain electrical meters and testing instruments in good condition to verify that the circuit is de-energized before beginning work.
  • Communicate your intentions to work on an electrical circuit to ensure the circuit is, and remains, protected.
  • Provide safe access to all working areas.
  • Discharge all capacitors after the circuit has been locked out.
  • Relieve hydraulic and pneumatic pressure after equipment has been locked out and before performing maintenance.
  • Isolate all energy sources, including electric, hydraulic, mechanical and pneumatic, before commencing work.
The Dont's
  • Never defeat manual or automatic de-energizing devices.
  • Never remove guarding to perform maintenance or inspection until the machine has been properly de-energized and locked out.
  • Never perform maintenance or work on moving machines.
  • Never rely on someone else to de-energize or disconnect a circuit for you.
  • Never remove someone else's lock or tag.
  • Never perform work on an electrical circuit before testing to make sure it has been de-energized.
  • Never remove or disturb an electrical lock or tag.
  • Never assume that a circuit breaker will not be reset by someone else. Always lock it out.
  • Never loan or share your lock or key with someone else.


Some or all of the files available on this page are PDF. For more information on PDF, PDF readers and accessibility issues, please use this link.